![nand x dash version nand x dash version](https://cdn.transcend-info.com/Products/images/ModelPic/982/RC-MTS830_feature_01.png)
Opening your Xbox 360 renders your warranty null and void. DO NOT use or buy this product if you are looking to perform any illegal activity. We do not support nor encourage, if possible, potential infringements of others intellectual property rights - please do not contact us with any question related to this use as we will not respond. It does not enable any kind of piracy or have any code whatsoever that circumvents any kind of protection. This device is designed primarily to aid or assist in the repair or replacement of defective hardware and also for the use of and development of legal open source software. TX 50Ohm Low Loss Double Shielded CPU_RST Cable for PHAT or SLIM
#Nand x dash version install
TX SLIM QSB Install Kit V2 (bundled POST QSB V1 and SLIM QSB Install Kit V1) TX NAND to COOLRUNNER Pin Header cable set Those of you looking for a similar setup as the TX NAND-X RGH Edition V3, we recommend the following items that are available for purchase separately: Supports New QSB V3 Kits (Solder Separately)Ĭable For QSB V3 Kit or Wires Install (QSB V3 Kits Sold Separately)Ĭable for Xecuter Sonus 360 (Sonus 360 QSB Sold Separately – Trinity Kit or Corona Kit)
![nand x dash version nand x dash version](https://weekendmodder.com/images/phat_TX_nand_wiring.png)
Rock Solid Design – Tested by the J-Runner Team RED LED FLASHING: R/W Activity & POST Activity (Switch to the right)Ĭompatible with all CoolRunners inc the new CR3 Proīuilt-in Programmer For Future Firmware Upgradesĭesigned for the latest J-Runner App (Build 283+) GREEN LED: J-R Programmer Mode (Switch to the right) RED LED: Bootloader Mode (Switch to the left) Onboard LED's indicate Power and BootLoader mode.
#Nand x dash version update
The J-R Programmer V2 is also fully upgradeable and can be programmed using the Xecuter X360USB PRO Update app. If you don't use the QSB's you can simply cut off the connectors and do a normal wires only install. Also comes with NAND installation wires that have the connectors that are compatible with the NAND-X QSB boards. The new TX J-R Programmer V2 has been created to cater to the budget conscious and coded to work hand in hand with the latest version of the J-Runner app.Ī third of the size of the TX NAND-X and optimized to run faster than any other USB-SPI based tool (Example Speeds: Others average 16M read 7m 20s, JRP v2 average 16M read 3mins), this nifty tool can fully read/write NAND over SPI, program CoolRunners or any Xilinx based RGH device over USB and also able to program onboard sounds using the TX SONUS 360 !Ĭomplete with a CR JTAG cable so you simply plug 'n program without any soldering using the latest J-Runner App (needs to be at least Build 283). Also includes speed enhancements (2-3 minutes faster than JRP v1 !)
#Nand x dash version full
NEW V2.0 Version with Full POST Monitoring and CR3 Pro Rater Support.